The hacker R & D team around the developer Martin Vilsmeier has once again achieved a big hit with this new Q80-11 PSD Senstrol!
An uncompromising revision has succeeded in further improving the weight-performance ratio. The overall length has shrunk to the size of the Q80-XS. The most important reason why the available power is significantly higher than the normal Q80, especially with this engine, is the unique Senstrol technology. Not only the motor and controller are 100% matched, but the motor is driven by a real sine wave. By this control the motor can be operated with more power and has a higher efficiency at the same time with less power loss and heat generation. Compared to the standard Q80-11 the new Q80-11 PSD Senstrol comes with up to 25% more power!
Like every Q80 also this Q80-11 PSD Senstrol is built, tested and measured by hand in-house.
Quality "Made in Germany" for the highest demands.
Specifications
Power range
max. 3400W (15 sec.)
Idle Current @ 8.4V
1.1A
Resistance (Ri)
0.02 Ohm
RPM/Volt (kv)
205 U/min-1
Weight
620g
Outer diameter
88.5mm
Length
65.5mm
Number of poles
28
Controller recommondation
Master Senstrol 120A Opto
Typical setups
Prop
Xoar CFK 21x13
Mejzlik 20x14EL 3Bl.
Falcon 20x13,5 3Bl.
V / LiPo
37V = 10S LiPo
37V = 10S LiPo
37V = 10S LiPo
Amp.
92A
91A
90A
Power
3400W
3367W
3330W
RPM
6480
6000
6270
Controller
Master Senstrol 120A Opto
Master Senstrol 120A Opto
Master Senstrol 120A Opto
Specifiactions
max. power range [W] (max.15 sec.)
3400
Poles
28
Turns
11
Idle current (I0) at 8.4V [A]
1,1
Internal resistance (Ri) [Ohm]
0,02
Recommended timing [°]
durch ID-Chip vorgegeben
Switching Frequenzy [kHz]
durch ID-Chip vorgegeben
Controller recommendation [A] (depending on setup)